• What can I do if the camera doesn't detect motion or misses detection?

  Check your device's installation if it is battery-powered. (a) Make sure the camera is installed at 7-10 ft (2-3 m) and adjust the angle to about 15°. Then the motion can be triggered as designed. (b)  Straighten the camera to get the best performance. ![addb310_pic_install2_2x.png](https://storage.crisp.chat/users/helpdesk/website/-/c/c/a/8/cca8c61e7fe23000/fSome readers

• How to configure detection range and motion sensitivity?

  Go to the device's Settings > Smart Detection > Motion Sensitivity or Radar Sensitivity, then adjust the detection range. A smaller number means less sensitivity and a lower detection range.Some readers

• How to set up an activity zone?

  In some cases, trees swaying, pedestrians and cars can cause unwanted notifications. Hence, you can set activity zones to detect your areas of interest and improve the detection accuracy. Go to Camera Settings – Motion Settings - Activity Zone, tap "+" icon at the top-right corner to add an activity zone. You can add up to 3 zones.Some readers

• Motion detection for battery-powered devices

  Motion detection and event recording On supported battery cameras, a PIR sensor detects changes in infrared radiation and can wake the camera. Image-based detection then evaluates the scene according to the model's supported detection features and settings. Available detection types vary by model. Recording length and retrigger interval Power modes, clip-length limits and intervals between triggers depend on the camera model and firmware. Check the controls available in that camera's settingsFew readers

• What does Person Only detection mean?

  If the Person Only mode is enabled, the device only detects persons. Otherwise, it detects all motions.Few readers

• Why might a Noorio camera move on its own?

  Checks to make if a Noorio camera view appears to move.Few readers