How to add B200-SE/B210-SE

B200-SE/B210-SE preparation

Use the Noorio app and a 2.4GHz home Wi-Fi network. These models do not support 5GHz Wi-Fi or Hub association. Do not assume that the app automatically filters every incompatible network.

During Wi-Fi setup, connect the phone to the intended home Wi-Fi on a band supported by the camera. Temporarily turn off the phone's VPN, mobile data, automatic switching to mobile data and dual-Wi-Fi features where present. Keep one Wi-Fi connection active and keep the setup app open. Restore normal phone network settings after setup succeeds.

Adding the camera

Open Add Device, scan the camera's label and select the matching model/setup flow. When QR-code Wi-Fi configuration is offered, select the home 2.4GHz network and enter its password accurately. Use the button identified on the device and follow the model's setup prompts; SYNC/RESET is the general label when the hardware revision is uncertain.

Show the app-generated QR code to the camera with sufficient screen brightness and without reflections. Adjust the distance gradually, keep the app open and complete the confirmation after the camera acknowledges the code.

No response or setup failure

For a compatible rechargeable camera with a depleted battery, the indicator may remain off initially. Use its specified supply, charge for about 10 minutes and check again. If still unresponsive, continue to a total of about 3 hours, then hold SYNC/RESET for about 10 seconds and check for an indicator or voice response. Older IVP devices use SYNC; newer models use RESET. Three hours is a diagnostic checkpoint, not proof of a full charge; at least 8 hours may be needed, depending on the model. Always-powered devices require continuous power.

Persistent setup failures require the exact model, device identifier, app error, failed step, approximate time and the checks already completed. An operation video showing the app and indicator response can support further diagnosis. A voice prompt alone does not prove that a camera is bound to another account. Do not remove a device from an account without verifying that this is necessary and authorized.

Updated on: 28/09/2026