How to set up SD200/SD400?

Step 1: Charge and Power On the Camera

After receiving the camera, charge it with a DC 5V 2A adapter for 6–8 hours to ensure the battery is fully charged.

Before setup, turn on the camera’s power switch (located inside the rubber cap near the camera mounting position).

Step 2: Scan the Device QR Code

Open the Noorio APP and scan the QR code label on the camera body. The system will automatically start the setup process.

Step 3: Select Installation Location

Choose the corresponding location based on your actual usage scenario (e.g., Front Door, Living Room), then tap Confirm.

Step 4: Name the Camera

Enter a custom name (e.g., Front Door, Bedroom Camera) for easy identification and management of the device later.

Step 5: Reset the Camera

Press and hold the SYNC button inside the rubber cap on the camera head until you hear a voice prompt and the indicator flashes red and blue alternately. Release the button, then tap Next in the APP.

Step 6: Bluetooth Pairing

Find your camera in the APP’s Bluetooth list (the last few characters of the Bluetooth name match the end of the IH-prefixed serial number next to the QR code). Select it and tap Next.

Step 7: Connect to Home Wi-Fi

This camera supports both 2.4GHz and 5GHz dual-band Wi-Fi.

Enter the Wi-Fi name and password accurately, double-checking case sensitivity, spaces, and special characters. When confirmed, tap Next.

Step 8: Complete Setup

Keep your phone close to the camera with a stable connection, and wait for the APP to display “Setup Successful” to finish configuration.

If setup fails using the steps above, retry with the following method:

Tap Try another method in the APP and select Wi-Fi Configuration.

Enter the Wi-Fi name and password correctly (check case sensitivity, spaces, and special characters), then tap Next.

Press and hold the SYNC button inside the rubber cap on the camera head until you hear a voice prompt and the indicator flashes red and blue alternately. Release the button and tap Next.

A QR code will appear on your phone screen. Point the QR code at the camera lens, move your phone slowly forward and backward, then tap Next once you hear the camera’s voice prompt to finish the network connection.

Updated on: 19/03/2026