Wi-Fi Configuration Step1

• Download the Noorio App from the app store, open the app. click "Set Up a Device" and scan the QR code on the bottom of the camera. Then select "Wi-Fi Configuration (QR mode)."

Wi-Fi Configuration Step2

• Select the Wi-Fi network you want to pair with (Note: Only 2.4GHz networks are supported).
• Connect the device to the power adapter
• Wait until the device voice prompts and the LED flashes (the blue or red light of the device indicates that the device is in the distribution network state and can be added normally).
• If not, turn the black lens up, insert the SIM card ejector tool into the hole below the SD card(or other thin, long object), and hold down for at least 2 seconds until you hear the voice prompt. During network setup, make sure your phone is within 10 feet (3 meters) of the camera.

Wi-Fi Configuration Step3

• Point your camera lens at the QR code displayed on the app, keeping a distance of 6–8 inches. After hearing the camera's prompt, click "Hear the Prompt."Wait for the camera to pair successfully.

Hotspot Configuration Step1

• Download the Noorio App from the app store, open the app. Scan the QR code on the back of the camera, and click "Set Up a Device." Select "Hotspot Configuration (device hotspot)."

Hotspot Configuration Step2

• Select the Wi-Fi network you want to pair with (note: Only 2.4GHz networks are supported). Turn the black lens up, insert the phone card needle (or other thin, long object) into the small hole under the SD card slot, and hold down for more than 2 seconds until you hear the voice prompt

Hotspot Configuration Step3

• Select "Connect Device Wi-Fi," go to your phone's network settings, and connect to the "Cloud_xxxxxx" network.

Hotspot Configuration Step4

• Return to the app and wait for the camera to pair successfully.

Updated on: 07/01/2026